1. You should select "EH" on which Ion chamber is put.
2. You should select "Ch." on which you would like to use.
(You can monitor the count you selected "Ch.")
3. When "start" button is push, you can monitor the count.
- How to use "GUI Counter"
1. You should push "Setup" button. ("gui_axis_setup" is open)
2. You can setup "Device" and "axis".
And, you should decide "Speed" and software limit of "Upper" and "Lower".
3. Please select "Mode". ("ABS" or "Rel") And, When push "Go!".
- How to use "1-axis Scan"
1. You should push "Device",and the "Device" to be used is determined.
2. You should push "Axis",and the axis to be used is determined.
3. Please input scan range and step.
4. Please select hutch which Ion chamber is put.
5. You should input file name. After that, Please start scan.
